HLK-LD2410S Microamp Low Power Radar Sensing Module


Description

LD2410S is an ultra-low-power human presence millimetre wave sensor, including extremely simplified 24GHz millimetre wave sensor hardware and low-power human presence sensing intelligent algorithm firmware.

The hardware is equipped with an AIoT millimetre wave sensor, a high-performance 24GHz one-transmitter-one-receiver antenna and peripheral circuits; the low-power intelligent human presence sensing algorithm adopts the millimetre-wave sensor distance measurement technology and the ICL1112 chip's advanced proprietary radar signal processing and low-power control technology to achieve the precise sensing of motion, micro-motion and standing human bodies. The product is mainly used in indoor scenarios, sensing whether there is a moving or slightly moving human body in the area in low-power mode, and refreshing the detection results in real time.

The maximum sensing distance of moving human body is 8m, the trigger and hold thresholds of different zones, the human body presence status and target human body distance reporting frequency, as well as the unoccupied reporting time. Support GPIO and UART interface, plug and play, flexible application in different intelligent scenes and terminal products.

Features

  • Single-chip smart millimetre wave sensor SoC and smart algorithmic firmware

  • Ultra-small sensor size: 20 mm × 20 mm

  • Loaded with default sensing configuration, plug and play

  • 24GHz ISM band, FCC, CE, No Commission Spectrum Regulation certified

  • 3.3V power supply, support 3.0 V~3.6V wide voltage range

  • Average operating current 0.1mA@1Hz reporting frequency

  • Detection targets for motion, micro-motion and static human body

  • Real-time reporting of detection results

  • Provide visualisation tools to configure the detection distance range and target disappearance delay time

  • Supports sensing range division, completely shielded from any interference outside the range

  • Close range 0.2m sensing, no detection of blind zones

  • Motion human body sensing up to 8 m

  • Large detection angle, wall mounted horizontal coverage angle of ± 60 °

  • Support wall mounting

  • Support IAP online upgrade

Specification

  • Support band: 24~24.25GHz ISM band (FCC, CE, No Commission Spectrum Regulation Certification)

  • Maximum scanning bandwidth: 0.25GHz

  • Maximum equivalent omni-directional radiated power: 10dBm

  • Power supply voltage: 3.3V (3.0V~3.6V)

  • Ambient temperature: -40°C~+85°C

  • Average operating current: 0.12mA (0.04~0.6mA, 0.1mA@1Hz reporting frequency)

  • Detection targets: motion, micro-motion and stationary human body

  • Detection distance (wall-mounted/hanging height 1.5m): 10m (motion human target detection), 4m (stationary human target detection)

  • Size: 20mm x 20mm

Documents

3D:

Last updated

Was this helpful?