Last updated
This PM02 Power Module provides a simple way to supply regulated 5.2V to flight controller from the battery while providing current consumption and battery voltage measurements via analog signal through a 6 Pin JST-GH cable. It comes with pre-soldered wires, capacitor, and XT60 connector on both ends, along with shrink tubing on the PCBA for physical protection.
Designed to power autopilot flight controller, RC receiver, and APM accessories (GPS, radio)
Compatible with Pix32, Pixhawk4, Pixhawk4 mini, Pix32v5, and Durandal
Input Voltage: 2S-12S
PCB Cont. Current Rating: 60A
PCB Burst Current Rating: 100A (<60 Sec)
Max Current Sensing: 120A
Output: DC 5.2V & 3A Max
Voltage Divider: 18.182
Amperes per Volt: 36.364
Weight: 20g
- 1x Power Module with XT60 Connectors Board (pre-soldered) - 1x Electrolytic capacito: 220uF 63V (pre-soldered) - 1x Molex 6 Position Connector 15 cm - 1x JST GH 6 Position Connector 15 cm
