Last updated
WT32S3-21S is a development board based on ESP32-S3 for visuall player temostat washing machine mirowawe ove.erste ! touch sreen. The solution is s often aplied to knob sren control of car
Support rapid prototyping
LCD interface
FPC interface
Connect the downloader (ZXACC-ESPDB) via a USB-Type C cable. And then connect the WT32S3-21S board with the downloader (ZXACC-ESPDB) through an MX1.25-7P cable. As the downloader (ZXACC-ESPDB) has automatic data flow processing capabilities, the firmware can be downloaded automatically through the ESP32 Flash Download Tools.
As shown in Fig. 4: Select the firmware path at mark 1, and then fill in the burning address, usually 0X00. Note that this checkbox must be checked; Set the crystal frequency to be 40MHz at mark 2; Select 32Mbit for Flash size at mark 3; Select DIO for SPI MODE at mark 4; Select the COM port number recognized by the computer at mark 5; Select the baud rate at mark 6 (the higher the value is, the faster the firmware will be downloaded. Max. 1152000bps).
After the previous configuration, click START at mark 7 to start burning the firmware.
Complete the above steps, and then press the reset button on the back of the development board to start running the firmware
